Hello,
I have a problem with most of my equipments, and it’s because they are battery operated. I would really like to remove the batteries once they die, in order to replace them with a cable plugged to the sector.
For example, I have right now a hair clippers that can totally run if it’s wired and if the battery is okay, but refuses to run once the battery is dead, even plugged in.
I have only basic electrical knowledge amd I’m afraid to simply make a bridge to replace the batteries. Would someone of you know what is the best/easiest solution ?
Thanks for your attention !
Most could be replaced with an AC adapter wired to the battery terminals. You’d need to understand the voltage and amperage needed for each device.
Usually (but not always), something with 2xAAA batteries as pictured runs on 3v, so you could get a 3v probably around 500w ac adapter and wire it in and it would run. But you’d need to understand some basics about electronics and soldering to do AO.
It could be worth cross posting this to [email protected]
Did you already try to remove the batteries, without making a bridge?
The easiest solution is to buy wired clippers for $35 and be done with it.
