I’m new to Proxmox and have had Openwrt on an AP router for a while, but still am not all that good at it.

I followed a YouTube video yesterday to set up Openwrt as a Proxmox device. The idea being that I can patch all my containers through it and have a single IP address and many ports associated with it on my home lan.

But I’m also trying to get Mullvad VPN installed on it. When I’ve followed the instructions to install Mullvad I can no longer ping the outside world. If there’s any pointers to getting that going I’d be grateful. I followed the instructions on their website.

Questions: if I get Mullvad working is there a way for me to route some containers through that and others through my own IP, or do I need 2 openwrt containers to get this? I noticed that during the setup I removed the WAN from the LAN and just left Mullvad as an exit route, so I assume I would need a second LAN with the WAN for me to be able to route via it. If that is the case, can I route some through one LAN and some through a second?

  • Possibly linuxEnglish
    11·
    4 months ago

    I’ve never ran OpenWRT in a container. If you run into issues and want a OpenWRT machine you can pickup a router from Walmart for about $50.

    I did try to run Openwrt in a VM at one point but it was kind of a pain to configure and setup so I ended up not doing it that way.

    Anyway this is outside of my wheelhouse unfortunately and I also don’t support or endorse piracy of any kind. Hood luck to you I hope someone else chimes in. I assume you already posted this elsewhere but if you haven’t you should do so.