I’m almost wrapped up with filling voids, bark inclusions, and knot holes in the boards for the bookcase. If our garage was climate controlled I expect this process would have gone faster; the same could be said if I had more horizontal working space for staging and filling. Once everything is done curing I should be able to go back over each board with the finishing grits to reach 220 - after that it’s cutting to have a plumb edge and to create the shelf supports.
Since we’re popping the grain in between sandings (spraying lightly with water and allowing to dry, which swells the softer grain and allows for a smoother finish) I’ve been able to see what these will sort of look like once finished, but the small bits of epoxy that made it over the edges of some of these really make the grain look downright sexy.
Work space. I have a small collapsable bench and two jaw stands with a couple of 2x4s I use in my garage for my work surface. It all collapses when not in use. Love those jaw stands. Inherited the little bench and it works great too and is more stable. I tend to use the bench as my work area and the stands as supports but for quick jobs I will just use the stands.
I remember when I was young I use to use IR lamps in the winter when curing paint on my car.
Just a couple of ideas.
Currently I have two of the boards on the folding sawhorses and three more on a folding table, but I hear you and appreciate the suggestion. The IR lamp suggestion is clutch as well, I think I have several in the rabbitry for the buns’ overwinter comfort but didn’t think to use those for this. Now I’m wondering if I have spare chain lying around to make an adjustable fixture height apparatus. Good looks, thank you!
I think what I use to use was an IR spotlight in a portable spotlight fixture that had a clamp you could clamp about anywhere. Also make certain you have enough ventilation.