Seagate has introduced the Exos M series, a range of enterprise-grade mechanical hard drives available in 30TB and 32TB capacities. The two models, the 30TB CMR ST30000NM004K and the 32TB SMR ST32000NM003K, each offer a minimum of 3TB per disk and use a standard 3.
Just a reminder: These massive drives are really more a “budget” version of a proper tape backup system. The fundamental physics of a spinning disc mean that these aren’t a good solution for rapid seeking of specific sectors to read and write and so forth.
So a decent choice for the big machine you backup all your VMs to in a corporate environment. Not a great solution for all the anime you totally legally obtained on Yahoo.
Not sure if the general advice has changed, but you are still looking for a sweet spot in the 8-12 TB range for a home NAS where you expect to regularly access and update a large number of small files rather than a few massive ones.
HDD read rates are way faster than media playback rates, and seek times are just about irrelevant in that use case. Spinning rust is fine for media storage. It’s boot drives, VM/container storage, etc, that you would want to have on an SSD instead of the big HDD.
And oftentimes some or all of the metadata that helps the filesystem find the files on the drive is stored in memory (zfs is famous for its automatic memory caching) so seek times are further irrelevant in the context of media playback
It’s no ssd but is no slower than any other 12TB drive. It’s not shingled but HAMR. The sectors are closer together so it has even better seeking speed than a regular 12TB drive.
???
It’s absolutely perfect for that. Even if it was shingled tech, that only slows write speeds. Unless you are editing your own video, write seek times are irrelevant. For media playback use only consistent read speed matters. Not even read seek matters except in extreme conditions like comparing tape seek to drive seek. You cannot measure 10 ms difference between clicking a video and it starting to play because of all the other delays caused by media streaming over a network.
But that’s not even relevant because these have faster read seeking than older drives because sectors are closer together.
Not sure what you’re going on about here. Even these discs have plenty of performance for read/wrote ops for rarely written data like media. They have the same ability to be used by error checking filesystems like zfs or btrfs, and can be used in raid arrays, which add redundancy for disc failure.
The only negatives of large drives in home media arrays is the cost, slightly higher idle power usage, and the resilvering time on replacing a bad disc in an array.
Your 8-12TB recommendation already has most of these negatives. Adding more space per disc is just scaling them linearly.
Additionally, most media is read in a contiguous scan. Streaming media is very much not random access.
Your typical access pattern is going to be seeking to a chunk, reading a few megabytes of data in a row for the streaming application to buffer, and then moving on. The ~10ms of access time at the start are next to irrelevant. Particularly when you consider that the OS has likely observed that you have unutilized RAM and loads the entire file into the memory cache to bypass the hard drive entirely.
I’m real curious why you say that. I’ve been designing systems with high IOPS data center application requirements for decades so I know enterprise storage pretty well. These drives would cause zero issues for anyone storing and watching their media collection with them.
honestly curious, why the hell was this downvoted? I work in this space and I thought this was still the generally accepted advice?
Mainly because of that. Spinning rust drives are perfect for large media libraries.
There isn’t a hard drive made in the last 15 years that couldn’t handle watching media files. Even the SMR crap the manufacturers introduced a while back could do that without issue. For 4k video you’re going to see average transfer speeds of 50MB/s and peak in the low 100MB/s range, and that’s for high quality videos. Write speed is irrelevant for media consumption, and unless your hard drive is ridiculously fragmented, seek speed is also irrelevant. Even an old 5400 RPM SATA drive is going to be able to handle that load 99.99% of the time. And anything lower than 4K video is a slam dunk.
Everything I just said goes right out the window for a multi-user system that’s streaming multiple media files concurrently, but the vast majority of people never need to worry about that.
Because everything he said was wrong?
Because people are thinking through specific niche use cases coupled with “Well it works for me and I never do anything ‘wrong’”.
I’ll definitely admit that I made the mistake of trying to have a bit of fun when talking about something that triggers the dunning kruger effect. But people SHOULD be aware of how different use patterns impacts performance, how that performance impacts users, and generally how different use patterns impact wear and tear of the drive.
Come on man, everything, and mean everything you said is wrong.
Budget tape backup?
No, you can’t even begin to compare drives to tape. They’re completely different use cases. A hard drive can contain a backup but it’s not physically robust to be unplugged, rotated off site , and put into long term storage like tape. You might as well say a Honda Accord is a budget Semi tractor trailer.
Then you specifically called out personal downloads of anime as a bad use case. That’s absolutely wrong in all cases.
It is absurd to imply that everyone else except for you is less knowledgeable and using a niche case except you.
So I’m guessing you don’t really know what you’re talking about.
Oh hey, I did something right. That’s kinda neat
https://youtu.be/tKXO02VGrQ0
I am troubled in my heart. I would not have been told so in this way.