cross-posted from: https://lemmy.perthchat.org/post/321128

I have tried: taping them together, hot glueing them together and ziptying it right to the frame to prevent jiggle.

All have failed.

Right now, when I reconnect them and apply pressure, I can’t even get the engine to turn on anymore. But the speedometer still works and that signal is sent through the engine cable too.

Recently, sometimes the engine rear wheel barely rolls when I roll the bike backwards.

There are no ebike repair stores in my city.

  • graphito@beehaw.org
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I think at this point you might need a new cable, since the connection socket most likely loose on the inside. Once you got a new one, try ziptying the ends below the connection joint (to ease the stress on the joint), ziptie it to the frame (as you did last time) and bonding the connection itself with epoxy resin (could be found in hardware stores).

    While using adhesives (epoxy), make sure you cleaned the surfaces very well

      • dack@sh.itjust.works
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        Can you post a photo of your actual connector? Inspect it closely for broken/damaged pins. Where do the other ends of these cables go? If it’s a proprietary connector that’s hard-wired into the motor, then replacement cables might not be readily available. If the connector is broken and replacements are not available, then I would probably consider replacing the connectors with a soldered connection.

  • ShadowCatEXE@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    You could try zip ties. Put one on both the male and female side (where the cable meets the base of the connector). Then use one or two other zip ties to hold them together.

    I don’t have zip ties to show an example, but hopefully you get the idea. Might work temporarily until you can get a new cable.