• humanplayer2@lemmy.ml
    2·
    10 months ago

    Ok, I gæs it’d be about the same shipping to Denmark. Compared to sourcing from ThinkPad keyboards, I find it very appealing to not have to risk popping the pin pads of the pcb when desoldering the keyboard ribbon cable. I’ve caused a few casualties.

    Edit: Ah, I see you had to undsolder a ribbon cable from the controller board, too.

    • joh@lemmy.worldOP
      2·
      10 months ago

      You don’t have to desolder the ribbon cable. You could use some sort of ribbon cable connector, if you have one available. But I found it more practical to only have the wires I needed. And desoldering the ribbon cable was fairly straightforward.