• Gorroth@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      My printer has its place in our dining room (I know not perfect…). It’s next to our kitchen, so humidity also was a problem. Now I can’t complain.

  • SokathHisEyesOpen@lemmy.ml
    link
    fedilink
    English
    arrow-up
    2
    ·
    edit-2
    1 year ago

    That’s a damned good idea. I’m going to print that. I’ve been trying to figure out how to put my filament above my printer so I can ditch the tube.

  • Uninvited Guest@lemmy.ca
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I knew there were filament dryers, but having one that is a direct feed in to the printer is quite neat! Thank you for turning me on to this.

        • Gorroth@lemmy.worldOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Ah okay, then I was just too dumb to understand :D

          Actually… I used the dryer on a table to dry the shelf‘s PETG before the print. Just wasn’t able to use its direct feed function at this point :)

  • baliskos@lemmy.world
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    Excuse my lack of knowledge, I do not yet have a 3D Printer, but why do you need a filament dryer? Does the filament ship with residue from the manufacturing process that needs to be washed off?