- cross-posted to:
- [email protected]
- cross-posted to:
- [email protected]
So I like to use Xbox controllers (doesn’t matter if it’s first- or third-party) because I like the layout, it’s just comfortable to me. However I’ve noticed that on all my controllers in the past few years, the left thumb stick will start to “give out” over the course of a couple months. For instance I’ll be pushing it forward all the way, but it won’t register for some reason and my character will only move a little bit. Sometimes wiggling it a bit will fix it, sometimes it doesn’t. And it’s not like I’m squeezing the hell out of the controller or mashing the stick constantly; in fact it’s made me try to be more delicate with my controllers, even though I’m just playing the games normally.
Is it just how controllers are, or am I just getting the shit end of the stick?
You must log in or # to comment.
I’ve been servicing controllers for at least 25 years now. The new analog sticks they put in now are terrible. Particularly because they’re not actually analog anymore. Any dirt they pick up blocks the digital contacts and stops them from registering the stick position. That dirt gets pushed to the edges of the stick range and you end up with an outer dead zone.
WD-40 makes an electrical contact cleaner that works excellent when my Oculus controller starts drifting. Don’t even need to take it apart. Just pull the battery, spray and roll the stick around, and let it dry. It’ll be like brand new. Totally saved me from having to ship it back to the company. For Switch controllers or any controller with a battery that’s not easily removed and can’t be completely shut off, you’d need to actually take it apart to clean. I’ve seen guys do it without removing the battery, but you risk shorting them. Only one I’d be scared of is the PS5 controller. I’ve seen the breakdown on them and there’s a lot to damage accidentally in it. Otherwise, most controller breakdowns are pretty easy and can be found on youtube. Just takes the right tools, which you can get on Amazon for like $10.
Also, if you’re comfortable taking your joycons apart, there is a company that makes hall effect replacement joysticks for relatively cheap (gulikit). I have 2 sets of joycons I did that swap for and they work great. You can also tune the deadzone to be smaller on them giving you a touch more usable range, which is nice on such a small joystick.
PS5 controller disassembling isn’t that difficult. I did shell swaps on two of mine and it was a little finicky but manageable and I don’t have too much experience, personally. iFixIt have an awesome guide
Try searching for hall effect Controllers. They will be more expensive, but don’t need sliding surfaces or easily failing parts.
I use a controller with hall effect sticks for that reason. Mine was cheap and works great. Gamesir G7 SE is the one I use. I’m sure there are others out there now as there were a few being announced when I bought this one.
With the Switch controllers I found out the clicking action puts pressure on the back housing of the analog stick. Basically, the aluminum backing was bowing really bad. The best fix I found was to tape a couple layers of cardstock behind the housing so it made contact with the plastic shell. This presses the housing back into place, and also prevents it from protruding in the future.
Oh my god if this was the fix the whole time and Nintendo refused to fix it…
Right? They don’t even need new tooling, just a shim the size of the stick housing and tape. Two years in on fixing all four of my joycons and not a single instance of drift since.
