I have an emisar d2 and dt8 and both are ip 67 but so far any time i tried to use them in wet conditions water got into the body. The strange thing is they didnt actually break they just acted strange for a while and then after drying for a night everything seemed okay. Except my trust in emisar. They are both amazing lights but im always extremely carefull now when using them. Kinda dissapointed. Wanted to do a nld post about my dt8 but this how it ended up. Extra details: they both fogged up, the d2 didnt really turn off correctly. The dt8 worked perfectly for hours after submersion in water but when i changed the battery i noticed the head was audably and visibly bubbling water when i screwed on the cap.

  • D45@lemmy.world
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    Hanks water rating can and should be taken with a pinch of salt.

    My dt8s screws on the bezel were not as tight as they should be and can come loose over time, ideally he should use some low tensile strength loctite and a slightly higher viscosity lube like super lube and ensure the screws are at a reasonable tension.

    I do prefer the new screw on bezel for the switch. One of my D4V2s had a visible 1mm gap, fortunately I was able to pop it in the vise and sort it out but shouldn’t have shipped like that.

    I personally would never submerge my hanklights in water.

    • AItoothbrushOP
      link
      fedilink
      English
      arrow-up
      1
      arrow-down
      1
      ·
      1 year ago

      Still dissapointing for a one day old “ip67” light.

      • D45@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        I agree I would suggest you contact hank and explain your concerns with your lights im sure he will do what he can to make it right