Welcome to the Melbourne Community Daily Discussion Thread.

  • Thornburywitch@aussie.zone
    link
    fedilink
    English
    arrow-up
    6
    ·
    8 months ago

    Gutters certainly won’t be strong enough. The hook idea is NOT a good one. Might be some hints in the DIY section of the Bunnings website on setting up shade sails. There are firms that will install proper anchor points and shade sails, which sound like the best solution. Looking at 3-400 per window though in $$ or an unknown cost to install a sail to cover the whole side. You could also get a pine pole or two installed to support the shade sail(s) but this won’t be portable if you move. How much does it cost to run the air-con? And are you willing to risk an expensive repair to the guttering if they get damaged? There probably aren’t any cheap good solutions. Also consult @[email protected] who is probably better informed than all of us.

    • Taleya@aussie.zone
      link
      fedilink
      arrow-up
      4
      ·
      8 months ago

      yeah shade sails are called sails for a reason - but the ol bamboo blind could work if anchored to the wall

      • TinyBreak@aussie.zone
        link
        fedilink
        arrow-up
        2
        ·
        8 months ago

        I did look into that. Trouble is I have brick walls and dont have an impact driver so I cant DIY it. Even bamboo blinds are going to need proper tool to install (plus its windy AF near gipsland so they dont last 2 years if I dont take them down over winter)

        • Taleya@aussie.zone
          link
          fedilink
          arrow-up
          2
          ·
          8 months ago

          hmm, do you have a pic of the area above the window? If there’s gutters there has to be some sort of mount that can be used

        • melbaboutown@aussie.zone
          link
          fedilink
          arrow-up
          2
          ·
          edit-2
          8 months ago

          Saw that you own. I’m not an handyperson and have never done this but could you rent one and drill holes in the mortar, then tap in those little plastic plugs as anchors for screws?

          I’ve seen that done for attaching house numbers to brickwork but the mortar was my own idea.

          Mortar may be softer to drill into and easier to repair on mistakes or removal than the brick (someone else pipe up if this is a bad idea)