jtablerd@lemmy.world to 3DPrinting@lemmy.worldEnglish · 2 years agoSwitched to 0.8 nozzle on my ender not looking backlemmy.worldimagemessage-square18fedilinkarrow-up124arrow-down10
arrow-up124arrow-down1imageSwitched to 0.8 nozzle on my ender not looking backlemmy.worldjtablerd@lemmy.world to 3DPrinting@lemmy.worldEnglish · 2 years agomessage-square18fedilink
minus-squareShadowRam@kbin.sociallinkfedilinkarrow-up1·edit-22 years agoFor years now, I’ve always want to see someone try a dual nozzle setup. Same material, same filament, but two nozzles sizes. Small nozzle for outer perimeter at a low layer height. Large nozzle for inner perimeter and infill at higher layer heights. Maybe in the future, someone will find a way to control nozzle size dynamically.
For years now, I’ve always want to see someone try a dual nozzle setup. Same material, same filament, but two nozzles sizes.
Small nozzle for outer perimeter at a low layer height.
Large nozzle for inner perimeter and infill at higher layer heights.
Maybe in the future, someone will find a way to control nozzle size dynamically.