This is the only place in the whole print where this happens.

  • Mitchie151@lemmy.world
    link
    fedilink
    English
    arrow-up
    5
    ·
    1 year ago

    Looks like pretty classic underextrusion. Have you measured the filament diameter to see if it’s exactly 1.75mm? Even 0.1mm is enough to start causing problems. It’s prusament so should be good but worth looking! I can see underextrusion problems in more than just the problematic pillar, so worth playing with retraction and perhaps increasing temperature.

    • Rikudou_Sage@lemmings.worldOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      This happens from time to time regardless of filament, so I guess it might be the retraction settings, I’ll try adjusting them.